7:27 He also made ten bronze movable stands. Each stand was six feet long, six feet wide, and four-and-a-half feet high. 7:28 The stands were constructed with frames between the joints. 7:29 On these frames and joints were ornamental lions, bulls, and cherubs. Under the lions and bulls were decorative wreaths. 7:30 Each stand had four bronze wheels with bronze axles and four supports. Under the basin the supports were fashioned on each side with wreaths. 7:31 Inside the stand was a round opening that was a foot-and-a-half deep; it had a support that was two and one-quarter feet long. On the edge of the opening were carvings in square frames. 7:32 The four wheels were under the frames and the crossbars of the axles were connected to the stand. Each wheel was two and one-quarter feet high. 7:33 The wheels were constructed like chariot wheels; their crossbars, rims, spokes, and hubs were made of cast metal. 7:34 Each stand had four supports, one per side projecting out from the stand. 7:35 On top of each stand was a round opening three-quarters of a foot deep; there were also supports and frames on top of the stands. 7:36 He engraved ornamental cherubs, lions, and palm trees on the plates of the supports and frames wherever there was room, with wreaths all around. 7:37 He made the ten stands in this way. All of them were cast in one mold and were identical in measurements and shape.
7:38 He also made ten bronze basins, each of which could hold about 240 gallons. Each basin was six feet in diameter; there was one basin for each stand. 7:39 He put five basins on the south side of the temple and five on the north side. He put “The Sea” on the south side, in the southeast corner.